Lay out centers on a circle
Use this calculation when an applicable drawing calls for a full circle of equally spaced hole centers. The pitch circle diameter (PCD), also called bolt circle diameter (BCD), passes through the centers. It is not the diameter of the holes or the outside edge of a plate.
For a door-hardware mounting plate, first confirm the actual pattern on the product drawing. A circular trim outline does not mean its fixing holes lie on an equally spaced circle. This calculator generates the stated geometry; it does not supply missing manufacturer dimensions or authorize drilling a door.
Define the origin and numbering
Choose one origin on the drawing, with +x to the right and +y upward. Enter the circle center relative to that origin; it can have negative coordinates. The first-hole angle is measured from +x, with positive angles counterclockwise. The direction control changes the order of subsequent holes, not the sign convention for the first angle.
For example, a first angle of 90° places hole 1 above the circle center. Clockwise numbering then proceeds to the right. Record the viewing side with the coordinates: reversing the viewing side can reverse the apparent pattern. This coordinate convention is not a lock-handing convention.
Calculate angle, coordinates, and chord spacing
For diameter D, center (cx, cy), and N holes, radius r = D/2 and angular spacing magnitude Δθ = 360°/N. Starting at θ₀, add Δθ for counterclockwise numbering or subtract it for clockwise numbering:
xᵢ = cx + r cos θᵢ
yᵢ = cy + r sin θᵢ
The straight center-to-center distance between neighboring holes is D sin(180°/N). This is a chord, not the arc measured around the circle. The trigonometric relationships follow from the radius projections and the isosceles triangle joining adjacent centers; the angle and radian conventions are explained in OpenStax’s rotational variables.
The table lists each hole once. It does not add a duplicate center at the end of the full revolution. Displayed angles are normalized to 0° through values below 360°; rounding can display a value very close to 360° as 360.000°.
Check a four-hole example independently
Take a hypothetical 4 in circle centered at (1, 2) in, with four holes, first angle 0°, and counterclockwise numbering. The radius is 2 in, so the four centers are:
| Hole | Angle | x (in) | y (in) |
|---|---|---|---|
| 1 | 0° | 3 | 2 |
| 2 | 90° | 1 | 4 |
| 3 | 180° | −1 | 2 |
| 4 | 270° | 1 | 0 |
The angular interval is 90°. Each adjacent chord is √(2² + 2²) = 2√2 in, approximately 2.828 in / 71.842 mm. The distance between opposite centers is 4 in, which supplies a separate diameter check.
Changing only the center translates every coordinate without changing the chord. Changing the first angle rotates the pattern without changing its spacing. Clockwise numbering reverses the order; with this four-hole example it reaches the same four positions.
Use the coordinates with the drawing
Results use three-decimal displays and approximate trigonometry. Exact unit conversion is 1 in = 25.4 mm, as defined by NIST. A rounded coordinate is not an installation tolerance. Check independent dimensions on the drawing rather than repeatedly measuring from one rounded point to the next.
The tool accepts 2–100 holes and limits input diameter and center-coordinate magnitudes to 1 billion inches; those are software limits. It does not check hole diameters, edge distances, overlapping bores, fastener strength, or the available plate material. A partial arc or uneven pattern needs its actual coordinates.
For a straight row of centers, use equal hole spacing. For a supplied pattern that needs mirroring, rotation, or translation, use template coordinates. Keep the original drawing identity, viewing side, datum, and independent checks on the template verification sheet.