Dimensional comparison

Find the signed difference between target and measured dimensions, with an optional check against limits you supply.

Your inputs

State the same start point, end point, and direction for both values.
Measured-value limits (optional)

Supply both limits from your own applicable source. The endpoints are included.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

See how far the target is from your measurement, with the direction stated.

Only the entered dimension and limits are checked. Product compatibility, security, and code compliance are not assessed.

What is being compared

Compare a measured value with a target of the same kind, using a shared measurement reference. The signed difference tells you how much larger or smaller the target is. It is not a machining instruction or a compatibility approval.

Difference = target − measured

Define the reference first

For example, state “door edge to cross-bore center,” with the same edge reference and measurement direction for both values. Do not compare backset with bore diameter or combine measurements taken from different faces. Use the applicable manufacturer’s drawing when the door edge is beveled or the lock geometry is special.

Read the sign

A positive difference means the target is larger than the measured value. A negative difference means the target is smaller. A zero difference means equality of the entered dimensions, not complete product compatibility.

Display precision

Differences display to three decimal places using half-up rounding. A small positive or negative difference can display as +0.000 or −0.000 in; its original sign and value remain part of the calculation. Limit checks use the exact value before rounding.

Optional measured-value limits

If you have an applicable lower and upper limit, enter both in the stated limit unit. The tool checks the measured value, not the target or the difference, against that inclusive interval. Equal endpoints are supported. Both blank means no range check; a single supplied endpoint is incomplete.

Use only limits you can justify for the particular product and condition. The tool does not supply a tolerance or infer one from a rounded drawing. “Within your stated range” reports a numeric comparison only.

Worked examples

Difference in the same unit

Measured: 2 3/8 in. Target: 2 3/4 in. Shared reference: door edge to the specified cross-bore centerline.

The difference is 2.75 − 2.375 = +0.375 in, exactly +9.525 mm. The target is larger. These are hypothetical dimensions for arithmetic, not a product or installation recommendation.

Mixed units and boundaries

A measured 60.325 mm and target 2.375 in are exactly equal. The difference is 0.000 in, or 0.000 mm.

For an explicitly supplied interval of 2.375 to 2.75 in, measured 2.375 and 2.75 are both within the interval. Measured 2.374 is below; 2.751 is above. No such range is assumed unless you enter it.

FAQs

Does a zero difference mean the lock fits?

No. Lock type, door preparation, cylinder and tailpiece interfaces, handing, and other manufacturer conditions may remain unassessed. Security, fire suitability, accessibility, and egress are separate checks.

Can I mix inches and millimeters?

Yes. Choose the unit independently for the measured value, target, and optional limits. Inch fields accept decimal or fractional formats. Millimeter fields accept decimals.

Sources and limits

Unit normalization uses the exact relationship 1 in = 25.4 mm. Subtraction and inclusive interval comparison use exact rational values. See References. Product-specific dimensions and limits must come from your applicable source; none is embedded here.