Correct a reference that printed too small or too large
A template’s printed reference line can differ from its stated length when an application scales the page. Measure that line and record the print-scale percentage used. This tool calculates a proportional correction for the next print. You can download a PDF calculation record, but the tool does not generate a scale drawing or drilling template.
Let L be the length stated on the template, p the measured printed length, and c the percentage used to print it:
Required size multiplier = L ÷ p
Next print-scale setting = c × L ÷ p
Measured size error (%) = 100 × (p − L) ÷ L
A line that is too short needs a multiplier greater than one. A line that is too long needs a multiplier below one. The signed size error describes the current print; it is not the percentage that should simply be added to the print setting.
A 10-inch line printed at 9.8 inches
Suppose a 10 in reference measures 9.8 in on a print made at 100%. Its error is −0.2/10 × 100 = −2%. The required multiplier is 10/9.8 = 50/49, approximately 1.020408×. The next setting is approximately 102.041%.
Adding exactly two percentage points would produce 9.8 × 1.02 = 9.996 in, rather than 10 in. The ratio corrects the measured size proportionally.
If the same 9.8 in measurement came from a print made at 50%, the correction would instead be 51.020%. This is why the current setting is an explicit input. With a line already measuring exactly 10 in, the multiplier is 1 and the current setting remains unchanged.
Verify the next print independently
The formula assumes printed size changes proportionally with the selected scale and other settings remain the same. Automatic fit-to-page behavior, driver overrides, or a changed page size can invalidate that assumption. Measure the new reference rather than treating the calculated setting as a guarantee.
Check a second reference and both axes. A single horizontal line cannot reveal unequal x/y scaling, rotation, or local image distortion. It also cannot verify that an old or rescaled drawing matches the current manufacturer’s template.
Both lengths and the current percentage must be positive. Inches can be fractional; millimeters and the percentage use decimals. Length comparisons and ratios use exact arithmetic; the multiplier displays six decimals, and percentage settings and errors display three. A printer may accept fewer digits, so its actual setting needs another measured check.
The correction follows directly from proportional scaling. Lengths may be expressed in either supported unit as long as the same unit is used for both; see the unit relationship. For transforming a hole pattern’s coordinates rather than correcting a physical print, use the template coordinate calculator.