Full-mortise hinge width calculator

Calculate minimum open hinge width using Hager’s stated full-mortise geometry and dimensions you supply.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

Nonnegative; less than door thickness. This is not lock backset.
Nonnegative clearance as defined in the Hager diagram, not a guessed frame allowance.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

Hager’s full-mortise hinge geometry only: the closed door/frame relationship and required clearance must match the referenced drawing. Hinge backset is measured from the back face, not the lock backset. No standard product size or load rating is selected.

Use the full-mortise drawing before the formula

This tool implements the width relationship in Hager’s Determine the Size of Hinge. Open hinge width is the width with the leaves opened flat; it is not hinge height. Use the diagram to identify the back face, hinge backset, and required clearance. Hinge backset is different from lock backset.

Hager discusses a wood door flush with a wood frame/casing and wood or metal doors inset in hollow-metal frames. The relevant closed position and clearance geometry must match your application. The article’s illustrative backsets and inset dimensions are not automatically applied here.

Formula and independent example

Minimum open hinge width = 2 × (door thickness − hinge backset) + required clearance

Hypothetical inputs of 1.75 in, 0.25 in, and 1 in give 2 × (1.75 − 0.25) + 1 = 4 in, or 101.6 mm. A backset of zero is allowed; one equal to or greater than door thickness is rejected. Zero additional clearance is a geometric boundary case.

Interpret the calculated width

The result is a conditional geometric minimum, not an available hinge size. Check actual manufacturer dimensions, configuration, rating, fasteners, reinforcement, and installation instructions. This formula does not cover every butt hinge, swing-clear hinge, pivot, or concealed hinge. No upward rounding to a purported standard size is performed. Exact input arithmetic is retained until three-decimal display rounding.