Router template offset calculator

Find guide-bushing offset and nominal rectangular template dimensions for an internal window or external template.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

Must exceed the cutter diameter. Check the actual guide and cutter combination.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

A concentric round guide and cutter, kept against a straight template edge. Dimensions describe the nominal rectangular envelope; corner radius, tool runout, guide height, and product fit are not checked.

Account for the space between guide and cutter

When a round guide bushing follows a straight template edge, the cutting edge does not reach that edge. The single-edge offset is the difference between the guide’s outside radius and the cutter radius. Lee Valley’s Router Template Guides explains this relationship and distinguishes routing inside a window from routing around an external template.

Single-edge offset = (guide outside diameter − cutter diameter) ÷ 2

Enter the actual guide outside diameter and cutter diameter. The outside diameter determines the offset, but it does not prove the cutter fits through the guide: internal clearance, guide length, collet clearance, and the router manufacturer’s requirements also matter.

Internal window or external template?

For an internal window, the guide rides inside the opening and the cut remains smaller than the window. Add the offset at both opposing edges:

Window dimension = finished dimension + 2 × offset

For an external template, the guide follows the outside and the cut is larger than the template. Subtract both edge offsets:

External template dimension = finished dimension − 2 × offset

Width and height are each adjusted once by the full diameter difference. Subtracting or adding the full difference at every edge would double the compensation incorrectly.

A rectangular mortise envelope example

Suppose the guide outside diameter is 5/8 in, the cutter diameter is 3/8 in, and the required finished envelope is 1 × 2 1/4 in. These are hypothetical values, not a lock installation specification.

  • The diameter difference is 5/8 − 3/8 = 1/4 in.
  • The single-edge offset is 1/8 in = 3.175 mm.
  • An internal window is 1.250 × 2.500 in, or 31.750 × 63.500 mm.
  • An external template for the same finished envelope is 0.750 × 2.000 in, or 19.050 × 50.800 mm.

If the external-template subtraction leaves a width or height of zero or less, the selected dimensions cannot form a positive rectangular template under this model. The calculator rejects that case instead of treating it as a usable template.

Envelope dimensions do not define the corners

The results describe nominal distances between opposing straight edges. A round cutter leaves a curved internal corner; a guide also has to travel around the template’s corners. This calculator does not construct that corner geometry or determine whether a particular faceplate will seat in the finished recess.

The model assumes the guide and cutter are concentric and remain against the intended edge. Runout, guide misalignment, wear, material movement, and machining allowance can change the actual cut. Test the setup on suitable scrap and follow the applicable tool and hardware instructions before modifying a door.

Inputs must be positive, and the guide outside diameter must exceed the cutter diameter. Inch dimensions accept fractions; millimeters accept decimals. Results round to three decimal places using decimal half-up rounding. Intermediate dimensions remain unrounded. A displayed offset is a geometric compensation, not a recommended fit clearance. Use dimensional comparison when checking a measured recess against limits explicitly supplied by the hardware manufacturer.