Inch & millimeter converter

Convert fractional or decimal inches to millimeters, or decimal millimeters to inches, with explicit rounding.

Your inputs

Inches: 2.375, 3/8, or 2 3/8. Millimeters: decimal only.
Display rounding only. Exact values stay unchanged.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your converted measurement and exact relationship will appear here.

A converted or rounded dimension is not an installation tolerance.

How the conversion works

The inch is exactly 25.4 millimeters. Convert inches to millimeters by multiplying by 25.4; convert millimeters to inches by dividing by 25.4. A mixed fraction is its whole number plus its fractional part.

Millimeters = inches × 25.4
Inches = millimeters ÷ 25.4

Fractional inputs

In inch mode, enter 3/8, 2 3/8, or 2.375. Put a space between the whole number and fraction. The fractional part of a mixed number must be less than one. Do not include unit symbols, commas, or a hyphen. In millimeter mode, enter a decimal number, such as 60.325.

Exact values and rounding

Choose zero to six decimal places. Displayed decimals use half-up rounding; an exact halfway value rounds upward in magnitude. An exact result remains available separately, as a reduced fraction if its decimal repeats. For example, 1 mm is exactly 5/127 in.

Rounding and tolerance

A result displayed as 60.33 mm does not establish an acceptable manufacturing or installation range. Compare an original measurement with the applicable manufacturer’s dimensions and explicit limits.

Worked example

For a measurement of 2 3/8 in:

  1. Convert the fraction: 2 + 3 ÷ 8 = 2.375 in.
  2. Multiply: 2.375 × 25.4 = 60.325 mm, exactly.
  3. At two decimal places, display 60.33 mm. At three, display 60.325 mm.

This arithmetic example is not a recommended backset or a product specification.

Using the result

Record the measurement reference along with the number. For backset, identify the door-edge reference and the manufacturer’s specified centerline. Cross-bore diameter, edge-bore diameter, and door thickness are different dimensions; converting their units does not make them interchangeable.

Use dimensional comparison when you have a measured value, a target, and a shared measurement reference.

FAQs

Can I enter zero?

Yes. Zero is a valid conversion input. Negative lengths, empty values, zero denominators, and unsupported formats are rejected.

Why not round every metric measurement to a whole millimeter?

That would change the displayed measurement by an amount you did not choose. This tool makes display precision explicit and retains the exact conversion.

Sources and limits

The inch-to-millimeter relationship follows NIST’s unit conversion references. See References for the source and interpretation. Inputs are limited to 64 characters and 12 decimal places to keep parsing bounded; those software limits are not physical fit limits.