Continuous hardware length calculator

Build a piece-length takeoff with quantities, your per-piece extras, and an explicit additional purchasing allowance.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

One length, quantity pair per line. Include each return or separate run as a segment. Up to 50 rows; each quantity 1–1,000.
Combined end and joint allowance for each piece, supplied by you. Enter 0 for none.
Applied after per-piece extras; enter 0 for none. Maximum 100% is a software limit.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

A linear piece list with the same user-entered end/joint extra on each piece. The percentage is an additional purchasing allowance on that total, not a measured waste rate or an optimized stock-length plan.

Turn measured runs into a piece-length budget

Continuous seals, strips, and similar linear hardware are purchased as lengths but installed as separate pieces. A takeoff needs each required run and its quantity, together with any explicitly chosen end or joint allowance. This tool keeps the piece list separate from an additional purchasing allowance.

Enter a net length and quantity for each repeated segment. Include returns and other separate runs as their own segments. The extra length input is the total extra per piece, including both ends and any applicable joint allowance; it is not automatically doubled.

Apply the allowances in order

For segment lengths Li, quantities qi, common per-piece extra e, and additional purchasing percentage p:

Net length = Σ(qi × Li)
Piece count = Σqi
Cut-length total = net length + piece count × e
Purchasing length budget = cut-length total × (1 + p ÷ 100)

The percentage is applied after the per-piece extras. It is an extra budget chosen by you, not an observed waste rate or a substitute for checking actual stock lengths. The same per-piece extra applies to every row; if pieces need different details, prepare separate takeoffs rather than treating one value as universal.

Example: two long runs and one head piece

For two 80 in pieces and one 36 in piece, with a hypothetical 1/2 in total extra per piece and 10% additional purchasing allowance:

Stage Independent calculation Length
Net pieces 2 × 80 + 36 196.000 in
Three per-piece extras 3 × 0.5 1.500 in
Cut-length total 196 + 1.5 197.500 in
Purchasing budget 197.5 × 1.10 217.250 in = 5,518.150 mm

The piece list shows two pieces at 80.500 in and one at 36.500 in before the percentage allowance. The extra percentage is not assigned to individual cuts.

With both allowances explicitly set to zero, the purchasing length equals the 196 in net total. A blank allowance produces an input error rather than silently implying zero.

A total length is not a cutting plan

The budget does not establish how many commercial stock lengths to buy. Separate pieces can leave unusable offcuts, and a required piece may not fit a short stock length even when the overall purchased total is sufficient. Use the stock cutting planner to explore identical usable stock lengths and a stated kerf model.

Follow product instructions for joints, corners, compression, fixing, and length allowances. This arithmetic does not select a seal profile, establish product compatibility, or approve a rated opening.

The tool supports 1–50 rows and whole-number quantities from 1 to 1,000 per row; the additional percentage is limited to 0–100% as a software bound. Net lengths must be positive. Results use exact sums and three-decimal half-up displays; see References for units.