Door bottom gap profile calculator

Compare a level door-bottom elevation with explicitly surveyed floor elevations and a gap you supply.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

Signed, relative to your vertical datum.
Nonnegative value supplied by you; no code or product default.
One signed elevation per line, same datum; 1–50 surveyed points along the relevant sweep/profile.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

One fixed level bottom elevation and a finite list of measured floor elevations sharing a vertical datum. Only entered points are checked. A geometric bottom-elevation increase is not permission to trim a door, especially a rated assembly.

Survey before estimating a bottom adjustment

Use a common vertical datum for the door bottom and every floor point. This tool assumes the door bottom stays level at one elevation. Enter floor elevations at measured positions along the relevant profile or swept area; keep a separate survey record of those positions.

Point gaps and geometric adjustment

Gap at point i = bottom elevation − floor elevation i
Required elevation increase = max(0, stated minimum gap − smallest entered gap)

A negative gap means the modeled bottom is below that measured floor point. Raising the bottom in this geometry increases all point gaps equally. The result does not specify a permissible cut or alteration.

Independent example

For bottom elevation 0.75 in, floor elevations 0, 0.25, 0.5 in, and required gap 0.5 in, point gaps are 0.75, 0.5, 0.25 in. The minimum is 0.25 in and geometric elevation increase is 0.25 in. If the required gap is 0.25 in, increase is zero. Blank rows are errors rather than zero-elevation assumptions.

Up to 50 points are evaluated with exact input arithmetic, then rounded to three decimals. No interpolation or claim about unmeasured floor areas is made. Door sag, changing bottom elevation, seals, thresholds, fire/smoke requirements, and manufacturer limits require separate assessment. The leaf dimensions tool handles a stated opening/gap chain rather than a surveyed floor profile.