Door edge bevel calculator

Relate a straight door-edge bevel angle to its face-to-face offset and sloped length through the door thickness.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

Greater than -90 and less than 90. Zero is square.
Far-face edge x minus near-face edge x. Use the same reference direction.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

A straight edge through two parallel door faces. The angle is measured from a square edge; a positive offset moves the far-face edge in +x. No standard bevel, cutting allowance, or permitted door modification is inferred.

Relate the edge angle to the two door faces

For a straight beveled edge through two parallel door faces, the face-to-face offset depends on door thickness and the angle from a square edge. This is a geometric relationship, not a recommended bevel for a particular lock, latch, or door.

View an edge section with the near face at y = 0 and far face at y = t. Let x run along the face. The signed offset s is the far-face edge’s x-coordinate minus the near-face edge’s x-coordinate. A positive angle moves that far edge in +x; a negative angle moves it in −x. This convention does not identify a door’s handing or which physical side should be cut.

Offset s = t tan θ
Sloped edge length = t ÷ cos θ
From a known offset: θ = atan(s ÷ t)

Here θ is measured from square, so θ = 0° gives no offset and a sloped length equal to the perpendicular thickness. It is not the angle between the edge and a door face. The supported angle is strictly between −90° and +90°.

A deliberately large, easy-to-check example

With t = 1.75 in and θ = 45°, tan 45° = 1, so the offset is 1.750 in = 44.450 mm. The sloped length is 1.75√2, approximately 2.475 in = 62.862 mm. These hypothetical values make the triangle easy to verify; they are not an installation recommendation.

At −45°, the offset becomes −1.750 in while the sloped length stays positive and unchanged. Entering the 1.75 in offset instead of the angle returns 45°. At 0°, both modes describe a square edge.

Measure perpendicular thickness

Use the distance between the parallel faces, rather than a diagonal measurement along the beveled edge. The offset must be measured between corresponding edge locations in that same section. A varying edge profile, twisted door, rounded edge, or nonparallel faces cannot be represented by this single right triangle.

The offset can help reconcile face dimensions on a drawing. It does not determine how much stock may safely be removed, how a faceplate sits, or where a manufacturer defines a backset on a beveled edge. Use the actual hardware template for those references.

All results involving trigonometry are approximate and display three decimals without intermediate display rounding. Thickness and signed offset are bounded to 1 billion inches in magnitude solely for software calculation. Very steep calculated angles can round to 90.000° in offset mode; the entered offset and thickness still define the triangle, and the display is not a machining tolerance.

The formulas follow the tangent, cosine, and Pythagorean relationships in the edge section. Unit definitions are given in References. Use template coordinate transformation for a planar hole pattern rather than a through-thickness bevel.