Check the margin on every edge
A cover plate can be larger than an opening and still leave an edge exposed when their centers are offset. This tool checks a rectangular opening against a rectangular plate in the same plane. Their edges must be parallel: rotation, curved edges, and rounded corners are outside this model.
Enter the opening and plate width and height. Locate the plate center relative to the opening center: positive x moves the plate right, and positive y moves it up. Enter zero for a centered axis. The required margin is a minimum you supply for each side, not an assumed hardware requirement.
Why moving right reduces the left margin
For opening width w, plate width W, and x-offset x, the centered margin would be (W − w)/2. Moving the plate right moves its left edge inward and its right edge outward:
Left = (W − w) ÷ 2 − x
Right = (W − w) ÷ 2 + x
Bottom = (H − h) ÷ 2 − y
Top = (H − h) ÷ 2 + y
The same reasoning applies vertically, with opening height h and plate height H. Every margin must be at least the entered requirement. Equality counts as meeting that geometric requirement. With a required margin of zero, the result checks coverage alone.
An offset plate example
Use a 2 × 3 in opening, a 4 × 5 in plate, x = 1/4 in, y = 0, and a 1/2 in required margin:
| Side | Margin (in) | Margin (mm) |
|---|---|---|
| Left | 0.750 | 19.050 |
| Right | 1.250 | 31.750 |
| Bottom | 1.000 | 25.400 |
| Top | 1.000 | 25.400 |
All four margins exceed the entered 0.5 in requirement. Moving the plate to x = 0.5 in reduces the left margin to exactly 0.5 in, which still meets it. Moving farther right to x = 0.5001 in fails the requirement, even though the displayed left margin rounds to 0.500 in.
Interpret a negative margin
A negative margin means the plate edge falls inside the corresponding opening edge. It identifies a geometric exposure on that side. If the plate is narrower than the opening, moving it cannot create nonnegative margins on both opposing sides; one edge may improve while the other worsens.
Opening and plate dimensions must be positive. Offsets can be signed; the required margin must be zero or positive. Inch inputs accept fractions and millimeters accept decimals. Exact dimensions determine the check, and only the displayed margins are rounded to three decimal places.
Check the actual plate outline and fixings
Rounded corners can expose parts of an opening even when this rectangular-envelope calculation reports coverage. Escutcheons, raised profiles, door curvature, fastener holes, edge distance, bearing area, material strength, and rating suitability require the actual drawings and installation conditions.
The result means only that the entered rectangles meet the entered coverage margin. It does not establish complete trim fit or permitted door modification. Use offset bore geometry for two circular outlines and dimensional comparison for a single measured dimension with explicit limits. The formulas here come directly from the four edge coordinates relative to a common center; units follow the exact length relationship.