Offset bore geometry calculator

Check how two circular openings intersect and whether a proposed opening contains the existing opening.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

Nonnegative straight-line center distance. Enter 0 for concentric circles.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

Two ideal circles in the same plane. Containment includes boundary contact. A geometric result does not establish that enlarging or relocating a lock bore is permitted or structurally acceptable.

Will the proposed circle contain the existing opening?

Moving a hole center while increasing its diameter can still leave part of the original opening outside the proposed circle. Compare the actual diameters and the straight-line distance between centers. All three measurements must refer to the same plane.

The tool reports both the circles’ relationship and a directional containment check: does the proposed new circle contain the entire existing circle? These are different questions. One circle can lie inside the other while the proposed circle is the smaller one.

A signed containment margin

Let r be the existing radius, R the proposed radius, and d the center distance. The farthest point of the existing circle is d + r from the proposed center, so:

Minimum radial containment margin = R − d − r
Entire existing circle contained when R − d − r ≥ 0

A positive margin means the existing opening is strictly inside the proposed circle. Zero means boundary contact or coincidence. A negative value means some existing opening remains outside; its magnitude is the radial shortfall along the farthest direction. This margin is not the area of remaining material or the overlap area.

Example: an offset enlarged bore

For an existing 1 in diameter, a proposed 2 in diameter, and 1/4 in center distance, r = 0.5 in and R = 1 in:

1 − 0.25 − 0.5 = 0.25 in = 6.350 mm

The proposed circle contains the old circle with a minimum radial margin of 0.250 in. If the center distance increases to 0.5 in, the margin is zero and the circles are internally tangent; boundary contact is included in the containment result. At 0.5001 in, containment fails even though a three-decimal display of the margin may appear as -0.000 in.

How the relationship is classified

Center distance Relationship
d > r + R Separate circles
d = r + R External tangency
|R − r| < d < r + R Two-point overlap
d = |R − r|, other than coincidence Internal tangency
d < |R − r| One circle contained inside the other
d = 0 and R = r Coincident circles

The equality checks use the unrounded input dimensions. Both diameters must be positive; center distance may be zero. Inch dimensions accept fractions, while millimeters accept decimals. Results show three decimal places with half-way ties rounded away from zero.

Geometry is only one part of bore modification

The model has no information about the lock body, backset, reinforcement, nearby edge bore, fasteners, door construction, or permitted field modifications. Containment does not prove that enlarging or relocating a bore is acceptable, that a lock will fit, or that a door assembly retains its rating.

Use the applicable manufacturer template and installation instructions for that decision. For a rectangular opening concealed by a plate, use cover plate coverage, which checks individual edge margins instead. Circle classification and containment here follow elementary center-distance geometry; References covers the exact unit conversion.