Solve one stated operating point
Voltage, current, resistance, and power describe different aspects of a DC circuit. For one positive steady operating point, two independent known values determine the other two under V = IR and P = VI. All six known pairs belong to this one calculator.
OpenStax’s discussion of Ohm’s law distinguishes ohmic and nonohmic behavior. A resistance inferred from a lock or electronic device at one voltage is an equivalent value at that point; it does not establish that the device will draw proportional current at another voltage.
| Known pair | Remaining values |
|---|---|
| V and I | R = V/I; P = VI |
| V and R | I = V/R; P = V²/R |
| I and R | V = IR; P = I²R |
| V and P | I = P/V; R = V²/P |
| I and P | V = P/I; R = P/I² |
| R and P | V = √(PR); I = √(P/R) |
V is in volts, I in amperes, R in ohms, and P in watts. Electrical power is the rate of energy transfer, not a battery’s amp-hour capacity.
A 12-volt example across all modes
At 12 V and 0.5 A, the equivalent resistance is 12/0.5 = 24 Ω and power is 12 × 0.5 = 6 W. Entering any corresponding pair—such as 24 Ω and 6 W—returns the same 12 V, 0.5 A, 24 Ω, 6 W operating point.
For example, the resistance/power mode uses √(24 × 6) = √144 = 12 V and √(6/24) = 0.5 A. These are hypothetical values, not product ratings. A zero current would make V/I undefined, so the tool consistently requires positive known values rather than representing open- or short-circuit special cases.
Keep the model at the right boundary
Use the voltage across and current through the same load. Do not combine a converter’s input voltage with its output current. Use the DC converter load calculator when crossing that boundary, or the load budget to add several devices under explicit simultaneous conditions.
Only the selected pair is used. Other fields are disabled, and changing the pair clears the old result. Decimal input is required; fractions and scientific notation are rejected. Results display three decimals. Five modes use exact rational arithmetic before display rounding; the resistance/power mode uses numerical square roots and labels those derived values approximate. Small positive values may round to zero.
The calculation does not verify startup behavior, inductive transients, allowable voltage, thermal rating, wire protection, or power-supply suitability. It supplies a mathematical operating point from the values you provide.