Door center of mass calculator

Calculate a composite door assembly’s three-dimensional center of mass from component masses and coordinates.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

One mass, x, y, z per line; up to 50 components. Signed coordinates use the selected length unit. Include every component once.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

All component masses are positive and use one common mass unit. Coordinates locate each component’s own center of mass relative to the same origin and axes. No hinge selection or structural adequacy is inferred.

Locate the assembly’s mass, not just its total

A door leaf with attached hardware may have an off-center mass distribution. After obtaining each component’s mass and its own center coordinates, this tool combines them. The door weight calculator instead estimates total mass from a uniform solid’s volume and density, or a rectangular panel’s area and applicable mass per area.

Set a common origin and positive x, y, z directions on your drawing. Coordinates can be negative; masses must be positive. Components must not overlap in your accounting: entering a complete door mass and then adding hardware already included in that measurement double-counts it.

Weighted-coordinate method

x̄ = Σ(mᵢxᵢ) / Σmᵢ; ȳ = Σ(mᵢyᵢ) / Σmᵢ; z̄ = Σ(mᵢzᵢ) / Σmᵢ

This is the center-of-mass relationship. The common mass conversion factor cancels, so pounds and kilograms give the same coordinates when all masses are converted consistently.

Check an independent example

For 80 lb at (18, 40, 0) in and 20 lb at (30, 40, 0) in, x̄ = (80 × 18 + 20 × 30) / 100 = 20.4 in. The y coordinate is 40 in and z is 0 in. One component returns its entered center; two equal masses at opposite coordinates return the origin.

Results round to three decimals, after the weighted sums and division. Up to 50 rows are supported. Unknown component centers cannot be inferred from mass alone. The output does not establish hinge loads, fastener capacity, deflection, or safe installation.