Ideal door support reactions calculator

Calculate gravity reactions for an ideal door with two radial supports and a single lower thrust support.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

A force, not a mass value in kilograms.
Nonnegative perpendicular offset.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

Rigid, static door; vertical support axis; lower support alone carries vertical thrust; both supports provide radial force and no moment. Weight acts at a horizontal offset. These imposed support conditions do not describe arbitrary real hinges or multiple-hinge load sharing.

Start with the support assumptions

This is a specified free-body model, not a hinge-rating calculator. Two radial supports lie on one vertical axis. The lower support alone carries the vertical weight; the upper support carries no vertical thrust. Both provide horizontal force but transmit no moment. Gravity is the only applied load.

Enter the door’s weight as a force in lbf or N, the horizontal center-of-mass offset from the support axis, and vertical support separation. Pounds-force must not be confused with kilograms of mass.

Force and moment equilibrium

Horizontal reaction magnitude at each support = weight × horizontal offset / vertical separation
Lower upward thrust = weight; upper vertical thrust = 0

The horizontal reactions are equal and opposite, forming a couple to balance the gravity moment. The upper reaction acts opposite the horizontal direction from the support axis toward the center of mass; the lower reaction acts in that direction. The method follows static force and moment equilibrium.

An independent check

For 100 lbf, an 18 in offset, and 60 in separation, each horizontal reaction is 100 × 18 / 60 = 30 lbf. The lower upward thrust is 100 lbf. A zero offset produces zero gravity-induced horizontal couple in this ideal model; separation must be positive. Displays round to three decimals after calculation.

Real hinges can share vertical thrust, transmit moments, deflect, and engage with different clearances. Three or more supports generally require additional stiffness/contact information. This model does not divide weight equally among hinges, predict actual bearing loads, or approve hinge or fastener capacity.