Door rotational inertia calculator

Calculate rotational inertia and kinetic energy for a uniform rectangular door leaf about a stated parallel vertical axis.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

Signed coordinate in the closed leaf plane.
Signed coordinate.
Nonnegative instantaneous speed, not degrees per second.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

Uniform rigid rectangular leaf only. Pivot coordinates lie in its width/thickness plane; height does not affect inertia about a parallel vertical axis. Real layered doors, attachments, damping, impact, and powered-door safety limits are not modeled.

Inertia depends on where mass lies relative to the pivot

Two leaves with the same mass can resist angular acceleration differently if their widths or axis positions differ. This tool assumes uniform mass throughout a rectangular leaf. Set the pivot’s x and y coordinates from the leaf’s width/thickness corner; the rotation axis is vertical and parallel to its height.

Uniform body plus axis shift

Icenter = m(w² + t²)/12
Iaxis = Icenter + m[(w/2 − px)² + (t/2 − py)²]
Rotational kinetic energy = Iaxis × ω² / 2

The formula uses the parallel-axis theorem and moments of inertia. Lengths are converted to meters and mass to kilograms before calculating. Height does not enter this particular vertical-axis inertia when total mass is known.

Independent example

Use hypothetical 1 m width, 0.1 m thickness, 12 kg mass, pivot (0, 0.05) m, and speed 2 rad/s. Center inertia is 1.01 kg·m²; the axis shift adds 3 kg·m², giving 4.01 kg·m². Kinetic energy is 8.02 J. Zero angular speed gives zero kinetic energy while inertia remains unchanged.

Mass and dimensions must be positive. Three-decimal outputs are numerical estimates of the uniform model. A nonuniform or composite door needs its actual mass distribution; attachments are not silently included as point masses. The result does not specify stopping force, allowable energy, operator selection, impact behavior, or safety compliance. The center-of-mass tool handles component positions but does not itself determine their distributed inertia.