Slot travel calculator

Calculate the extreme-to-extreme travel of a round bolt in a straight slot with semicircular ends.

Your inputs

Inches accept decimals and fractions. Millimeters accept decimals. Changing units reinterprets the numbers; it does not convert them.

Outside end to outside end, not semicircle-center separation. Must be at least the slot width.
The semicircular end diameter.
Must not exceed the slot width. A zero-clearance geometric case is allowed.

Enter your values or load the labeled example.

Your result

Waiting for your inputs

Your results will appear here after calculation.

Straight capsule-shaped slot with semicircular ends and an ideal round bolt. Travel is the full extreme-to-extreme bolt-center movement, not simultaneous movement in both axes. Washer bearing, strength, and required clearance are not checked.

Separate slot length from adjustment travel

For a straight slot with semicircular ends, a round bolt’s center cannot reach the slot’s outer edge. This calculator finds the ideal extreme-to-extreme movement of the bolt center, along and across the slot. It can help interpret adjustment geometry on a drawing; it does not approve a slotted connection or a modification to hardware.

Measure overall slot length L from outside end to outside end. The slot width W is also the diameter of each semicircular end. Enter the bolt shank diameter b, rather than the head or washer diameter.

Three different distances

Semicircle-center separation = L − W
Longitudinal bolt-center travel = L − b
Transverse bolt-center travel = W − b

The slot is a capsule: two semicircles joined by straight parallel sides. Its end-circle centers are L − W apart. The bolt center stays at least b/2 from each end, leaving L − b between its farthest longitudinal positions.

The longitudinal and transverse results are each the full movement between opposite extremes. They are not a pair of simultaneous x/y movements near an end, where the curved boundary restricts the available position. From a centered bolt, the ideal movement to either extreme on one axis is half the corresponding total.

Example: a one-inch slot

For L = 1 in, W = 3/8 in, and b = 1/4 in:

Quantity Calculation Inches Millimeters
End-circle center separation 1 − 3/8 0.625 15.875
Total longitudinal travel 1 − 1/4 0.750 19.050
Total transverse travel 3/8 − 1/4 0.125 3.175

Confusing the center separation with bolt travel would understate longitudinal travel by W − b = 0.125 in in this example. Conversely, treating the full 1-inch slot length as center travel would overstate it by the bolt diameter.

Boundary cases

The dimensions must satisfy L ≥ W ≥ b > 0. When L = W, the slot becomes a circular hole; the bolt still has the same total clearance W − b along any diameter. When b = W, transverse travel is zero and longitudinal travel is L − W. This zero-clearance case is a valid geometric boundary, not a practical installation recommendation.

Negative travel is rejected. Inch inputs may be fractions; millimeters use decimals. Results use exact dimension arithmetic and three-decimal half-up display rounding. A comparison is not based on a rounded result.

What the available movement does not establish

The model omits washers, head shape, thread interference, plate thickness, angular misalignment, manufacturing tolerances, required edge distance, bearing area, and connection strength. Actual permitted movement may be smaller than the geometry suggests. Follow the specific assembly drawing and fastening instructions.

For a row of separate holes, use equal hole spacing. For the relation between two offset circular openings, use offset bore geometry. The relationships on this page follow directly by subtracting the relevant end radii; see References for the unit definitions.